Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 5L-E) › from 2016.01
RM3250E _54 Brake _038045 BRAKE SYSTEM (OTHER) _0250463 VACUUM PUMP(for 5L-E) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 5L-E)  REASSEMBLY  


PROCEDURE

Hide 29341A 1.INSTALL OIL SEAL

a.
C353198N01
2.333,1.146 2.99,0.646 2.99,0.646 2.438,1.354 true 3.042,0.552 3.344,0.729 0.302,0.177 10 true SST

Using a SST and a hammer, tap in the oil seal.

SST
09950-60010  09950-70010  (09951-00400, 09951-07150)


Hide 29342B 2.INSTALL O-RING

a.

Apply engine oil on a new O-ring and install the O-ring to the vacuum pump case.


Hide 29322B 3.INSTALL VACUUM PUMP BEARING

a.
F043198

Using a press, press in a new vacuum pump bearing to the vacuum pump shaft.


Hide 29336 4.INSTALL VACUUM PUMP SHAFT

a.

Install the vacuum pump shaft and stop ring to the vacuum pump case.


Hide 29331 5.INSTALL VACUUM PUMP BLADE

a.
C353199C01
0,0 0,0 false
V100135

Engine oil


Apply engine oil to the vacuum pump rotor and 5 new vacuum pump blades.


b.

Install the rotor and pump blades with the round end facing outward.


c.

Install the end plate with the 2 screws.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


Hide 6.INSTALL VACUUM PUMP END COVER

a.

Install the vacuum pump end cover with the 4 screws.

Torque:
4.6 N*m (47 kgf*cm, 41 in.*lbf)


Hide 29369 7.INSTALL CHECK VALVE SUB-ASSEMBLY

a.

Using soft jaws, place the vacuum pump in a vise. Then install a new gasket and check valve sub-assembly.

Torque:
73.5 N*m (749 kgf*cm, 54 ft.*lbf)


Hide 29300F 8.INSTALL VACUUM PUMP VACUUM HOSE UNION

a.
C353200N01
2.26,0.385 2.5,0.24 2.5,0.24 2.677,0.24 false 2.729,0.177 3.063,0.354 0.333,0.177 10 false SST

Using SST, hold the check valve sub-assembly, and install 2 new gaskets and the vacuum hose union with the union bolt.

SST
09922-10010  

Torque:
13.7 N*m (140 kgf*cm, 10 ft.*lbf)


Hide 29366 9.INSTALL VACUUM PUMP PULLEY

a.

Install the vacuum pump pulley with the pulley lock nut.

Torque:
105.3 N*m (1074 kgf*cm, 78 ft.*lbf)