Make sure to release the vacuum from the brake booster before removing the brake master cylinder sub-assembly from the brake booster assembly.
1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
47101A
2.REMOVE BRAKE PEDAL RETURN SPRING
47264A
3.REMOVE PUSH ROD PIN
47264D
4.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Loosen the push rod clevis lock nut.
Remove the brake master cylinder push rod clevis.
5.DISCONNECT VACUUM HOSE
for 2KD-FTV:
Slide the clip and disconnect the vacuum hose from the brake vacuum check valve assembly.
for 1TR-FE, 2TR-FE:
Slide the clip and disconnect the 2 vacuum hoses from each brake vacuum check valve assembly.
47201
6.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
44610
7.REMOVE BRAKE BOOSTER ASSEMBLY
for 2KD-FTV:
Remove the brake vacuum check valve assembly from the brake booster assembly.
Remove the vacuum warning switch assembly from the brake booster assembly.
Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM WARNING SWITCH(for Diesel)>REMOVAL
Remove the 2 grommets from the brake booster assembly.
for 1TR-FE, 2TR-FE:
Remove the 2 brake vacuum check valve assemblies from the brake booster assembly.
Remove the 2 grommets from the brake booster assembly.
Remove the 4 nuts.
Pull out the brake booster assembly with the brake booster gasket.
Do not damage the brake lines.
44785
8.REMOVE BRAKE BOOSTER GASKET