Home › Brake › BRAKE (REAR) › REAR BRAKE(for TSAM Made 2WD) › from 2016.01
RM3250E _54 Brake _038047 BRAKE (REAR) _0250236 REAR BRAKE(for TSAM Made 2WD) A

BRAKE (REAR)  REAR BRAKE(for TSAM Made 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42403 1.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

a.

Install a new brake drum gasket and rear brake drum sub-assembly.


Hide 2.ADJUST REAR DRUM BRAKE SHOE CLEARANCE

a.

Temporarily install 2 wheel nuts.


b.
C353228C01
0,0 0,0 false
V113147

Expand


Using a screwdriver, remove the shoe adjusting hole plug, and turn the adjuster to expand the shoe until the drum locks.


c.
C353229C01
0.917,0.979 0.469,0.625 0.469,0.625 0.271,0.625 true 0.083,0.563 0.281,0.719 0.198,0.156 10 false *1
*1 Rear Brake Automatic Adjust Lever
V113147

Contract


Hold the rear brake automatic adjust lever away from the adjuster, and contract the brake shoe by turning the adjustment bolt using another screwdriver until the drum rotates smoothly.

Standard:

11 notches



d.

Install the shoe adjusting hole plug.


e.
C353227

Measure the brake drum inner diameter and the diameter of the brake shoes. Check that the difference between the diameters is equal to the specified shoe clearance.

Standard Shoe Clearance:

0.5 mm (0.0197 in.)



Hide 3.BLEED BRAKE LINE (w/ VSC)

Hide 4.BLEED BRAKE LINE (w/o VSC)

Hide 5.BLEED BRAKE LINE (w/o ABS)

Hide 6.BLEED CLUTCH LINE (for Manual Transmission)

Hide 8.CHECK PARKING BRAKE LEVER TRAVEL

Hide 9.ADJUST PARKING BRAKE LEVER TRAVEL