Operating the ECO mode switch illuminates the ECO indicator light in the combination meter. This displays the ECO mode condition.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ECO Switch | ECO mode switch status | ON or OFF | ·
ON: ECO MODE switch being pressed and held ·
OFF: ECO MODE switch not pressed |
- |
| Tester Display |
|---|
| ECO Switch |
| Result | Proceed to |
|---|---|
| Data display is within Normal Condition range | A |
| Data display is not within Normal Condition range | B |
A
B
| *a | Front view of wire harness connector
(to ECO MODE Switch) |
Disconnect the ECO MODE switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I5-2 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECO MODE switch connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I5-4 (ECU) - G46-13 (ECMS) | Always | Below 1 Ω |
| I5-4 (ECU) or G46-13 (ECMS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the ECO MODE switch.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>ECO SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG