Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
88625
1.INSTALL NO. 1 COOLER THERMISTOR (FRONT EVAPORATOR TEMPERATURE SENSOR)
| *A | w/o Stop and Start System |
| *B | w/ Stop and Start System |
Install the No. 1 cooler thermistor (front evaporator temperature sensor) as shown in the illustration.
Be sure to insert the No. 1 cooler thermistor (front evaporator temperature sensor) only once because reinserting it into the same position will not allow it to be firmly secured.
When reusing the evaporator, insert the No. 1 cooler thermistor (front evaporator temperature sensor) one row next to the one that has been used previously.
After inserting the thermistor, do not apply excessive force to the wire.
| Position | Measurement |
|---|---|
| a | 45 to 55 mm (1.78 to 2.16 in.) |
| b | 61.1 mm (2.41 in.) (9 Fins) |
| c | 45 to 55 mm (1.77 to 2.17 in.) |
| d | 23 to 27 mm (0.91 to 1.06 in.) |
| e | 41 mm (1.61 in.)(6 Fins) |
| f | 54.4 mm (2.14 in.)(8 Fins) |
| g | 61.1 mm (2.41 in.) (9 Fins) |
88501
2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88515
3.INSTALL COOLER EXPANSION VALVE
87107A
4.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY (for Automatic Air Conditioning System, Manual Air Conditioning System)
88650N
5.INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
82210K
6.INSTALL AIR CONDITIONING HARNESS ASSEMBLY (for Automatic Air Conditioning System)
87130D
7.INSTALL BLOWER ASSEMBLY
8.INSTALL AIR CONDITIONING UNIT ASSEMBLY