Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › ECD SYSTEM(w/ Urea SCR System) › from 2016.03
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0262511 ECD SYSTEM(w/ Urea SCR System) C

2GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  U1103  Lost Communication with Stop and Start Control Module  


DESCRIPTION

The ECM and engine stop and start ECU send and receive signals via CAN communication.

If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U1103 Lost Communication with Stop and Start Control Module There is no communication between the ECM and engine stop and start ECU (1 trip detection logic).
·

ECM

·

Engine Stop and Start ECU

·

CAN Communication System


- DTC stored

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
U1103 Ignition switch ON for 5 seconds or more

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT (DTC U1103)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Read the DTCs using the GTS.

Powertrain > Engine > Trouble Codes
50001 234

Result:
Result Proceed to
DTC U1103 is not output A
DTC U1103 is output B



A

B