The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the clock assembly removal/installation are shown below.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE UPPER INSTRUMENT PANEL
55950G
4.REMOVE DEFROSTER NOZZLE ASSEMBLY (w/ Navigation System)
55085
5.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)
55084E
6.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)
55844
7.REMOVE NO. 2 HEATER TO REGISTER DUCT (w/ Navigation System)
83910G
8.REMOVE CLOCK ASSEMBLY (Hazard Warning Switch)
Disconnect the connector.
Remove the screw and clock assembly (hazard warning switch).