When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0123 | Lost Communication with Yaw Rate Sensor Module | While the vehicle is being driven at 5 km/h (4 mph) or more, a communication error between the yaw rate and acceleration sensor (airbag sensor assembly) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Yaw rate and acceleration sensor (airbag sensor assembly) ·
Forward recognition camera |
| U0126 | Lost Communication with Steering Angle Sensor Module | 2 seconds after the ignition switch is turned to ON, a communication error between the steering angle sensor (spiral with sensor cable sub-assembly) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Steering angle sensor (spiral with sensor cable sub-assembly) ·
Forward recognition camera |
| U0129 | Lost Communication with Brake System Control Module | 2 seconds after the ignition switch is turned to ON, a communication error between the skid control ECU (brake actuator assembly) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Skid control ECU (brake actuator assembly) ·
Forward recognition camera |
| U0142 | Lost Communication with Body Control Module "B" | 2 seconds after the ignition switch is turned to ON, a communication error between the combination meter assembly and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Combination meter assembly ·
Forward recognition camera |
| U0155 | Lost Communication with Combination Meter | 2 seconds after the ignition switch is turned to ON, a communication error between the combination meter assembly and the forward recognition camera is detected for approximately 50 seconds or more. | ·
CAN communication system ·
Combination meter assembly ·
Forward recognition camera |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0123, U0126, U0129, U0142 and U0155 are not output | A |
| DTC U0123, U0126, U0129, U0142 or U0155 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING