Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST MAIN SWITCH › from 2016.03
RM3250E _51 Engine / Hybrid System _037980 CRUISE CONTROL _0262562 LANE-KEEPING ASSIST MAIN SWITCH G

CRUISE CONTROL  LANE-KEEPING ASSIST MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490A 1.INSPECT LANE DEPARTURE ALERT MAIN SWITCH

E197682C08
0.813,2 1.021,2 1.021,2 1.417,1.281 true 1.479,1.99 1.208,1.99 1.208,1.99 1.604,1.271 true 2.406,1.979 2.115,1.979 2.115,1.979 1.802,1.292 true 2.531,1.719 2.188,1.719 2.188,1.719 1.969,1.281 true 0.052,0.021 0.365,0.219 0.313,0.198 10 false *a 2.635,1.646 3.135,1.865 0.5,0.219 10 false GND 1.542,1.917 1.896,2.115 0.354,0.198 10 false ILL+ 2.531,1.885 2.885,2.083 0.354,0.198 10 false ILL- 0.458,1.938 0.813,2.135 0.354,0.198 10 false ECU
*a Component without harness connected
(Lane Departure Alert Switch)


a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (GND) - 6 (ECU) Lane departure alert switch pushed Below 1 Ω
Lane departure alert switch not pushed 10 kΩ or higher




b.

Inspect the illumination operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
LED illuminates


If the result is not as specified, replace the lane departure alert switch.