Home › Engine / Hybrid System › CRUISE CONTROL › FRONT CAMERA › from 2016.03
RM3250E _51 Engine / Hybrid System _037980 CRUISE CONTROL _0262563 FRONT CAMERA A

CRUISE CONTROL  FRONT CAMERA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after replaced the front camera are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Forward recognition camera Adjust forward recognition camera
·

Forward recognition camera system

·

LDA system

·

Road sign assist system

·

Pre-crash safety system


(Click here)

NOTICE:
·

When replacing the forward recognition camera, replace it with a new one.

·

Do not touch the camera lens or the front windshield glass in front of the camera.

·

If the forward recognition camera has been struck or dropped, replace it with a new one.

·

When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket, or the forward recognition camera system, lane departure alert system, road sign assist system or pre-crash safety system may not operate properly due to a difference in the transmissivity of the windshield glass or the shape of the black ceramic border.



PROCEDURE

Hide 86466D 1.REMOVE NO.1 FORWARD RECOGNITION COVER

a.
B443374

Detach the 2 clips and 2 guides and remove the No.1 forward recognition cover as shown in the illustration.

NOTICE:

Push the cover while keeping it parallel with the surface of the glass so as not to damage the clips and guides.



Hide 86464A 2.REMOVE FORWARD RECOGNITION LATCH

a.
B443375N02
1.969,2.688 2.135,2.875 0.167,0.188 10 true (1) 0.938,4.375 1.167,4.594 0.229,0.219 10 true (2)

Detach the 2 claws and 4 guides and remove the forward recognition latch as shown in the illustration.


Hide 8646C 3.REMOVE FORWARD RECOGNITION CAMERA

a.
B443376

Disconnect the connector.


b.

Detach the 4 guides and remove the forward recognition camera as shown in the illustration.

NOTICE:
·

Do not pull the harness forcibly when disconnecting the connector.

·

If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.

·

If the forward recognition camera has been struck or dropped, replace it with a new one.

·

Do not apply excessive force.