Home › Engine / Hybrid System › 2GD-FTV EMISSION CONTROL › EXHAUST GAS TEMPERATURE SENSOR(w/ Urea SCR System) › from 2016.03
RM3250E _51 Engine / Hybrid System _038008 2GD-FTV EMISSION CONTROL _0262566 EXHAUST GAS TEMPERATURE SENSOR(w/ Urea SCR System) A

2GD-FTV EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR(w/ Urea SCR System)  INSTALLATION  


PROCEDURE

Hide 89425C 1.INSTALL NO. 4 EXHAUST GAS TEMPERATURE SENSOR

a.
A329093C01
1.667,0.573 1.979,0.729 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using a 14 mm union nut wrench, install the No. 4 exhaust gas temperature sensor to the front exhaust pipe assembly.

Torque:
Specified tightening torque : 30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

If the No. 4 exhaust gas temperature sensor is dropped, replace it with a new one.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26 N*m (268 kgf*cm, 19 ft.*lbf)




b.

Attach the 2 clamps and connect the No. 4 exhaust gas temperature sensor to the sensor bracket.


c.

Connect the connector to the No. 4 exhaust gas temperature sensor.