Home › Engine / Hybrid System › 2GD-FTV EMISSION CONTROL › UREA INJECTOR › from 2016.03
RM3250E _51 Engine / Hybrid System _038008 2GD-FTV EMISSION CONTROL _0262567 UREA INJECTOR A

2GD-FTV EMISSION CONTROL  UREA INJECTOR  REMOVAL  


PROCEDURE

Hide 77840A 1.DISCONNECT UREA TUBE WITH HEATER ASSEMBLY

NOTICE:
·

Check for dirt or mud on the urea injector set and around the urea tube connector before disconnection. Clean if necessary.

·

In order to prevent the urea injector set interior portion from drying, perform installation and removal work as quickly as possible.



a.

Disconnect the urea tube with heater assembly from the urea injector set.

i.
A379841C01
0,0 0,0 false
V100135

Lift Up


Detach the lock claw by lifting up the cover.


ii.
A379842C01
0,0 0,0 false
V100135

Pinch
V100136

Pull


Pinch the retainer of the urea tube connector, and then pull the urea tube connector off of the urea tube with heater assembly.

NOTICE:
·

If there is any solidified urea solution (white solids) on the connection area, clean the solids off with a damp cloth, etc., before disconnecting the urea tube connector.

·

Be sure to disconnect the urea tube connector by hand.

·

Check for foreign matter in the urea injector set and around the urea tube connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the urea injector set and urea tube connector.

·

Put the urea injector set and urea tube connector ends in plastic bags to prevent damage and foreign matter contamination.





Hide 23203A 2.REMOVE UREA INJECTOR SET

a.
A379840

Disconnect the connector from the urea injector set.


b.
A379844

Remove the 2 nuts and urea injector set and gasket from the front exhaust pipe assembly.