Home › Engine / Hybrid System › 2GD-FTV STARTING › GLOW PLUG CONTROLLER › from 2016.03
RM3250E _51 Engine / Hybrid System _038012 2GD-FTV STARTING _0193799 GLOW PLUG CONTROLLER A

2GD-FTV STARTING  GLOW PLUG CONTROLLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the glow plug controller removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 28551 3.REMOVE GLOW PLUG CONTROLLER

a.
A379579

for LHD:

i.

Disconnect the 4 connectors and detach the clamp from the glow plug controller.


ii.
A379580

Remove the 2 bolts and glow plug controller.



b.
A346978

for RHD:

i.

Disconnect the 4 connectors and detach the clamp from the glow plug controller.


ii.
A346979

Remove the bolt and glow plug controller.



Hide 28559 4.REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.


Hide 28559A 5.REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 2 glow plug controller bracket from the glow plug controller.