Home › Engine / Hybrid System › 2GD-FTV STARTING › STARTER(for 2.7 kW Type) › from 2016.03
RM3250E _51 Engine / Hybrid System _038012 2GD-FTV STARTING _0199962 STARTER(for 2.7 kW Type) A

2GD-FTV STARTING  STARTER(for 2.7 kW Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53882K 3.REMOVE FRONT FENDER SEAL LH

a.

for 4WD and Pre-Runner:

Remove the 6 clips and front fender seal LH


b.

for 2WD:

Remove the 5 clips and front fender seal LH


Hide 51410 4.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

Hide 51442 5.REMOVE NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 6.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 28100 7.REMOVE STARTER ASSEMBLY

a.

Remove the starter terminal cap.


b.

Disconnect the starter connector.


c.
C331715

Remove the nut and disconnect the starter wire.


d.
C331716

for Automatic Transmission:

i.

Remove the 2 nuts, bolt and starter assembly and disconnect the ground cable.



e.
A360265

for Manual Transmission:

i.

Remove the bolt and disconnect the clutch flexible hose bracket.


ii.

Remove the nut, starter assembly and disconnect the ground cable.