Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM WARNING BUZZER(for LHD) › from 2016.03
RM3250E _58 Vehicle Interior _053993 PRE-CRASH SAFETY _0262631 PRE-CRASH SAFETY SYSTEM WARNING BUZZER(for LHD) G

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM WARNING BUZZER(for LHD)  INSPECTION  


PROCEDURE

Hide 86652E 1.INSPECT SKID CONTROL BUZZER

a.

Disconnect the skid control buzzer assembly connector.


b.

Check the connector and terminals for deformation and corrosion.

OK:

No deformation or corrosion.



c.
B376959C08
2.292,1.396 1.979,1.865 true 2.719,1.427 2.969,1.865 true 1.51,0.583 1.823,0.781 0.313,0.198 10 false *a 1.74,1.906 2.24,2.115 0.5,0.208 10 false 2(IG1) 2.813,1.885 3.25,2.094 0.438,0.208 10 false 1(BZ)
*a Component without harness connected
(Skid Control Buzzer)


Apply battery voltage and check the operation of the skid control buzzer according to the table below.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 2(IG1)
Battery negative (-) → Terminal 1(BZ)
Skid control buzzer sounds


If the result is not as specified, replace the skid control buzzer.