Home › Power Source / Network › 2GD-FTV BATTERY / CHARGING › GENERATOR(for 130 A Type) › from 2016.03
RM3250E _57 Power Source / Network _038059 2GD-FTV BATTERY / CHARGING _0263595 GENERATOR(for 130 A Type) A

2GD-FTV BATTERY / CHARGING  GENERATOR(for 130 A Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the generator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative when not Performed Link
w/ Stop and Start System:

Battery terminal is disconnected/reconnected


Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 74404B 3.REMOVE BATTERY CLAMP SUB-ASSEMBLY

a.

Loosen the 2 nuts.


b.
A347637

Remove the 2 battery clamp bolts and battery clamp sub-assembly.


Hide 28800 4.REMOVE BATTERY

Hide 74431 5.REMOVE BATTERY TRAY

Hide 17344E 6.REMOVE NO. 4 AIR HOSE

Hide 16361A 7.REMOVE FAN AND GENERATOR V BELT

Hide 27020 8.REMOVE GENERATOR ASSEMBLY

a.
A347638

Disconnect the intake air temperature sensor connector.


b.

Disconnect the generator connector and detach the clamp..


c.

Remove the terminal cap.


d.

Remove the nut and disconnect the wire harness from terminal B.


e.
A349099

Detach the 3 clamps and disconnect the wire harness..


f.
A347639

Remove the 2 bolts and generator assembly.


g.
A347640

Remove the 2 bolts and 2 generator brackets.