Home › Power Source / Network › 2GD-FTV BATTERY / CHARGING › BATTERY CURRENT SENSOR › from 2016.03
RM3250E _57 Power Source / Network _038059 2GD-FTV BATTERY / CHARGING _0263596 BATTERY CURRENT SENSOR A

2GD-FTV BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the battery current sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative when not Performed Link
w/ Stop and Start System:

Battery terminal is disconnected/reconnected


Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28850C 2.REMOVE BATTERY STATE SENSOR ASSEMBLY (BATTERY STATE SENSOR ASSEMBLY WITH NEGATIVE BATTERY TERMINAL)

a.
A350996

Remove the nut and detach the clamp from the battery current sensor holder.


b.

Remove the nut and disconnect the No. 3 engine wire from the battery state sensor assembly.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



c.

Disconnect the connector from the battery state sensor assembly.


d.

Loosen the nut and disconnect the battery state sensor assembly from the battery.


e.
A350997

Detach the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.