Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2016.03
RM3250E _58 Vehicle Interior _053993 PRE-CRASH SAFETY _0264409 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-crash safety system is not functioning properly, the driver is warned by the PCS warning light and a warning message displayed on the multi-information display.

Master Warning Indicator Warning Message Detail DTC PCS warning light
Illuminated "Pre-Crash Safety Malfunction Visit Your Dealer"*1 Pre-crash safety system malfunctioning Stored Blinks
"PRE-CRASH SAFETY MALFUNCTION VISIT YOUR DEALER"*2
Not illuminated "Pre-Crash Safety Unavailable"*1
·

Millimeter wave radar sensor assembly misaligned

·

Millimeter wave radar sensor assembly temperature malfunction

·

Millimeter wave radar sensor assembly low voltage malfunction


Not stored Blinks
"PRE-CRASH SAFETY UNAVAILABLE"*2
Not illuminated "Pre-Crash Safety Unavailable Clean Sensor"*1 Foreign matter attached to millimeter wave radar sensor assembly Not stored Blinks
"PRE-CRASH SAFETY UNAVAILABLE CLEAN SENSOR"*2
Not illuminated "Forward Camera System Unavailable"*1
·

Abnormal forward recognition camera voltage

·

Forward recognition camera temperature outside of operational range

·

Other forward recognition camera malfunction


Not stored Blinks
"FORWARD CAMERA SYSTEM UNAVAILABLE"*2
Not illuminated "Forward Camera System Unavailable Clean Windshield"*1 Foreign matter attached to forward recognition camera or area of windshield in front of forward recognition camera Not stored Blinks
"FORWARD CAMERA SYSTEM UNAVAILABLE CLEAN WINDSHIELD"*2
Not illuminated "VSC Turned Off Pre-Crash Brake System Unavailable"*1 VSC system is disabled Not stored Illuminates
"VSC TURNED OFF PRE-CRASH BRAKE SYSTEM UNAVAILABLE"*2

*1: for TFT Display Type

*2: for Dot Display Type


HINT:
PCS Warning Light Illumination Status
PCS Warning Light Condition
Blinks ON: 0.5 sec./OFF: 1.5 sec. Pre-crash safety system malfunctioning (DTC stored)
Pre-crash safety system temporarily disabled
Illuminates Pre-crash safety system disabled
VSC system disabled
Not illuminated Other




INITIAL CHECK


a.

An initial check is performed when the ignition switch is off for more than 2 seconds and then turned ON. The initial check consists of a pre-crash safety system diagnostic check with a duration of approximately 3 seconds.


b.

If a malfunction is detected during the initial check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-crash safety system is malfunctioning or disabled will be displayed on the multi-information display.



CONSTANT CHECK


a.

The millimeter wave radar sensor assembly constantly monitors the pre-crash safety system for malfunctions after the ignition switch is turned to ON and the initial check (approximately 3 seconds) has completed.


b.

If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-crash safety system is malfunctioning or disabled will be displayed on the multi-information display.