Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2016.03
RM3250E _58 Vehicle Interior _053993 PRE-CRASH SAFETY _0264409 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  


DESCRIPTION

These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-crash control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" When driving the vehicle at a speed of 5 km/h (4 mph) or more, a communication error between the ECM and the millimeter wave radar sensor assembly is detected for approximately 5 seconds.
·

CAN communication system

·

ECM

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0125 Lost Communication with Yaw Rate Sensor Module When the ignition switch to ON, a communication error between the yaw rate sensor (airbag sensor assembly) and the millimeter wave radar sensor assembly is detected for approximately 1 second.
·

CAN communication system

·

Yaw rate sensor (Airbag sensor assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0126 Lost Communication with Steering Angle Sensor Module When the ignition switch to ON, a communication error between the steering angle sensor (spiral with sensor cable sub-assembly) and the millimeter wave radar sensor assembly is detected for approximately 4 seconds.
·

CAN communication system

·

Steering angle sensor (Spiral with sensor cable sub-assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0129 Lost Communication with Brake System Control Module When the ignition switch to ON, a communication error between the skid control ECU (brake actuator assembly) and the millimeter wave radar sensor assembly is detected for approximately 3 seconds.
·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector



PROCEDURE

1.CHECK FOR DTCs (PRE-CRASH SAFETY SYSTEM)
a.

Clear the DTCs.

Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Crash 2 > Clear DTCs
50002 220

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Crash 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC U0100, U0125, U126 and U0129 are not output A
DTC U0100, U0125, U126 or U0129 is output B



A

B