Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › NITROGEN OXIDES SENSOR › from 2016.03
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0264434 NITROGEN OXIDES SENSOR A

2GD-FTV ENGINE CONTROL  NITROGEN OXIDES SENSOR  INSTALLATION  


PROCEDURE

Hide 89460B 1.INSTALL NITROGEN OXIDES SENSOR ASSEMBLY

a.
A349874C01
1.583,0.771 1.927,0.406 1.927,0.406 2.083,0.406 true 2.115,1.594 2.333,1.781 0.219,0.188 10 true *a 2.167,0.313 2.49,0.5 0.323,0.188 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the nitrogen oxides sensor assembly.

SST
09922-10010  

Torque:
Specified tightening torque : 70 N*m (714 kgf*cm, 52 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 132 mm (5.20 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 46 N*m (469 kgf*cm, 34 ft.*lbf)




b.

Install the bolt and connect the 6 clamps.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


c.

Connect the connector.