Home › Engine / Hybrid System › STOP AND START › STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY › from 2016.03
RM3250E _51 Engine / Hybrid System _053992 STOP AND START _0264442 STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY G

STOP AND START  STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 84470A 1.INSPECT STOP AND START SYSTEM CANCEL SWITCH

a.
A285506C07
0.938,1.833 1.354,1.417 false 2.365,1.844 1.979,1.417 false 0.771,1.896 1.229,2.094 0.458,0.198 10 ECU 2.354,1.875 2.865,2.177 0.51,0.302 10 E 0.073,0.052 0.594,0.531 0.521,0.479 10 *a
*a Component without harness connected
(Stop and Start System Cancel Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
8 (ECU) - 5 (E) Pushed Below 1 Ω
Not pushed 10 kΩ or higher


If the result is not as specified, replace the stop and start system cancel switch.


b.
A285506C05
1.104,1.844 1.521,1.427 false 2.198,1.833 1.792,1.417 false 0.052,0.083 0.521,0.604 0.469,0.521 10 *a 0.958,1.865 1.458,2.156 0.5,0.292 10 ILL+ 2.135,1.875 2.635,2.167 0.5,0.292 10 ILL-
*a Component without harness connected
(Stop and Start System Cancel Switch)


Apply battery voltage between the terminals of the switch, and check the illumination condition of the stop and start system cancel switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 7 (ILL+)
Battery negative (-) → 6 (ILL-)
Illuminates


If the result is not as specified, replace the stop and start system cancel switch.