The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ECM removal/installation are shown below.
55607
1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55550
2.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
8926A
3.REMOVE ENGINE STOP AND START SOLENOID FILTER (w/ Stop and Start System for Automatic Transmission)
89661
4.REMOVE ECM
| *A | for LHD |
| *B | for RHD |
for LHD:
Detach the 2 clamps.
for RHD:
Detach the 3 clamps.
for 4WD:
Disconnect the 2 4 wheel drive control ECU connectors and 6 ECM connectors.
Remove the bolt, 2 nuts and ECM with the 4 wheel drive control ECU.
for 2WD and Pre-Runner:
Disconnect the 6 ECM connectors.
Remove the bolt, 2 nuts and ECM.
89533
5.REMOVE 4 WHEEL DRIVE CONTROL ECU (for 4WD)
89667A
6.REMOVE NO. 1 ECM BRACKET
| *A | for LHD |
| *B | for RHD |
Remove the 2 screws and No. 1 ECM bracket.
89668A
7.REMOVE NO. 2 ECM BRACKET
| *A | for LHD |
| *B | for RHD |
Remove the 2 screws and No. 2 ECM bracket.