Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2016.03
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0192297 AIR FUEL RATIO SENSOR A

2GD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of air fuel ratio sensor Clear A/F Sensor Compensation data - (Click here)
w/ DPF:(Click here)
w/ Urea SCR System:(Click here)

CAUTION:
·
A343693

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 53882F 1.REMOVE FRONT FENDER SEAL RH

a.

for 2WD:

i.

Remove the 5 clips and front fender seal RH.



b.

for 4WD and Pre-Runner:

i.

Remove the 6 clips and front fender seal RH.



Hide 89467B 2.REMOVE AIR FUEL RATIO SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A349884N02
0.615,0.49 0.792,0.49 0.792,0.49 1.052,1.063 true 0.292,0.406 0.625,0.583 0.333,0.177 10 true SST

Disconnect the connector and clamp.


b.

Using SST, remove the air fuel ratio sensor.

SST
09224-00011