Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › DIESEL THROTTLE BODY › from 2016.03
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0192288 DIESEL THROTTLE BODY A

2GD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 26100G 1.INSTALL DIESEL THROTTLE BODY ASSEMBLY

a.

Connect the connector to install the emission control valve wire to the diesel throttle body assembly.


b.

Install a new gasket and the diesel throttle body assembly with the 2 bolts and 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the connector and clamp.


d.

for Cold Area Specification Vehicles:

Connect the No. 11 water by-pass hose and No. 14 water by-pass hose to the diesel throttle body assembly, and slide the 2 clips to secure the hose.


e.

Connect the fuel hose bracket with the bolt to the diesel throttle body assembly.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


Hide 17363K 2.INSTALL INTERCOOLER AIR TUBE

a.

Install the intercooler air tube to the diesel throttle body assembly and tighten the hose clamp.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


b.

Connect the connector to the intake air temperature sensor.


Hide 17344E 3.INSTALL NO. 4 AIR HOSE

a.

Install the No. 4 air hose to the intercooler air tube and tighten the 2 hose clamps.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


b.

Connect the oil return hose to the intercooler assembly and engine oil level dipstick guide, and slide the 2 clips to secure the hose.


c.

Attach the 4 clamps.


Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

a.

Attach the 2 clips and install the No. 1 engine cover sub-assembly to the No. 2 water by-pass pipe.


b.

Install the No. 1 engine cover sub-assembly to the No. 1 engine cover bracket and No. 2 engine cover bracket with the 2 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)