Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL SYSTEM(w/ Differential Lock) › from 2016.03
RM3250E _52 Drivetrain _038039 AXLE AND DIFFERENTIAL _0184154 DIFFERENTIAL SYSTEM(w/ Differential Lock) C

AXLE AND DIFFERENTIAL  DIFFERENTIAL SYSTEM(w/ Differential Lock)  U0122  Lost Communication with Vehicle Dynamics Control Module  


DESCRIPTION

This DTC is detected if communication is lost with the skid control ECU (brake actuator assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area
U0122 Lost Communication with Vehicle Dynamics Control Module
·

Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON)

·

Malfunction Status: Communication is lost between skid control ECU and 4 wheel drive control ECU

·

Malfunction Time: 0.72 seconds or more

·

Other: 1 trip detection logic


CAN communication system

CAUTION / NOTICE / HINT

NOTICE:
·

except Pre-Runner w/o Multi-information Display:

When the data in the skid control ECU (brake actuator assembly) is being overwritten, the 4WD indicator light and 4LO indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.

except Pre-Runner w/ Multi-information Display:

When the data in the skid control ECU (brake actuator assembly) is being overwritten, a message is displayed on the multi-information display and the 4LO indicator light rapidly blinks due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.

for Pre-Runner:

When the data in the skid control ECU (brake actuator assembly) is being overwritten, the rear differential lock indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.

·

Clear all DTCs, since DTCs are stored after the data in the skid control ECU (brake actuator assembly) is overwritten.



PROCEDURE