Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › from 2016.03
RM3250E _58 Vehicle Interior _038070 SUPPLEMENTAL RESTRAINT SYSTEMS _0189245 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the instrument panel passenger airbag assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION

for Type C:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 73960A 4.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:
B399173C01
0,0 0,0 false
V100155

Deployment Side


·

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.



a.

w/o Selectable Vent Hole:

i.

Using a screwdriver, release the connector lock and disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Tape the screwdriver tip before use.




b.

w/ Selectable Vent Hole:

i.

Using a screwdriver, release the 2 connector locks and disconnect the 2 airbag connectors.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Tape the screwdriver tip before use.




c.

Detach the wire harness clamp.

B445185C01
1.167,2.313 1.844,2.594 true 4.677,2.323 5.354,2.604 true 0.063,0.031 0.375,0.188 0.313,0.156 12 false *A 3.688,0.031 4,0.25 0.313,0.219 12 false *B 1.854,2.521 2.167,2.677 0.313,0.156 10 false *a 5.385,2.531 5.698,2.688 0.313,0.156 10 false *a
*A w/o Selectable Vent Hole *B w/ Selectable Vent Hole
*a Connector Lock - -
V100155

Protective Tape
V113147

Release in this Direction



d.

Remove the 2 screws.


e.

Insert moulding remover B into the side of the airbag door facing the rear of the vehicle and bend moulding remover B to detach the hook.


f.

Raise the instrument panel passenger airbag assembly in the direction indicated by the arrow shown in the illustration to detach the hook on the side of the airbag door facing the front of the vehicle and remove the instrument panel passenger airbag assembly.

B445186C01
0.115,0.031 0.427,0.188 0.313,0.156 12 false *A 3.677,0.042 3.99,0.208 0.313,0.167 12 false *B
*A w/o Selectable Vent Hole *B w/ Selectable Vent Hole
V113147

Raise in this Direction - -