Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › from 2016.03
RM3250E _58 Vehicle Interior _038070 SUPPLEMENTAL RESTRAINT SYSTEMS _0189245 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 73960A 1.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.

Attach the hook on the side of the airbag door facing the rear of the vehicle and set the instrument panel passenger airbag assembly onto the airbag door.


b.

Slowly pull the instrument panel passenger airbag assembly in the direction indicated by the arrow shown in the illustration to attach the hook on the side of the airbag door facing the rear of the vehicle and install the instrument panel passenger airbag assembly.


c.

Install the 2 screws.

B445187C01
0.021,0.031 0.333,0.188 0.313,0.156 12 false *A 3.635,0.042 3.969,0.24 0.333,0.198 12 false *B
*A w/o Selectable Vent Hole *B w/ Selectable Vent Hole
V113147

Slowly Pull - -



d.

Attach the wire harness clamp.


e.

w/o Selectable Vent Hole:

i.

Connect the airbag connector and push the connector lock.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.




f.

w/ Selectable Vent Hole:

i.

Connect the 2 airbag connectors and push the 2 connector locks.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


B445188C01
0.74,1.948 1.115,2.094 true 4.167,1.938 4.542,2.083 true 0.031,0.042 0.344,0.198 0.313,0.156 12 false *A 3.573,0.031 3.906,0.25 0.333,0.219 12 false *B 0.594,1.823 0.906,1.979 0.313,0.156 10 false *a 4.021,1.833 4.333,1.99 0.313,0.156 10 false *a
*A w/o Selectable Vent Hole *B w/ Selectable Vent Hole
*a Connector Lock - -
V113147

Push in this Direction - -




Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION