The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat airbag assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type B
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
for Type C
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE FRONT SEAT ASSEMBLY
72526E
4.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
72495
5.REMOVE VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)
71812D
6.REMOVE FRONT SEAT CUSHION SHIELD LH
71862
7.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY LH
71759C
9.REMOVE FRONT NO. 1 SEATBACK HOOK (w/ Seatback Hook)
71931
10.REMOVE FRONT SEAT HEADREST SUPPORT (for Low-back Seat Type)
11.REMOVE SEATBACK COVER WITH PAD
73920A
12.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH (for Hi-back Seat Type)
|
Deployment Side |
When storing the front seat airbag assembly LH, keep the airbag deployment side facing upward.
If the airbag deploys for any reason, it may cause a serious accident.
Detach the wire harness clamp.
Be careful not to damage the airbag wire harness.
Remove the 2 nuts and front seat airbag assembly LH.
The nuts must not be reused.
Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
| *A | for Type A | *B | for Type B |
73920A
13.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH (for Low-back Seat Type)
|
Deployment Side |
When storing the front seat airbag assembly LH, keep the airbag deployment side facing upward.
If the airbag deploys for any reason, it may cause a serious accident.
Detach the wire harness clamp.
Be careful not to damage the airbag wire harness.
Remove the 2 nuts and front seat airbag assembly LH.
The nuts must not be reused.
Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
| *A | for Type A | *B | for Type B |