Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73920A
1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH
Install the front seat airbag assembly LH with 2 new nuts.
The nuts must not be reused.
Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
Attach the wire harness clamp.
Be careful not to damage the airbag wire harness.
2.INSTALL SEATBACK COVER WITH PAD
71931
3.INSTALL FRONT SEAT HEADREST SUPPORT
71759C
4.INSTALL FRONT NO. 1 SEATBACK HOOK
5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY LH
71862
6.INSTALL FRONT SEAT INNER CUSHION SHIELD LH
71812D
7.INSTALL FRONT SEAT CUSHION SHIELD LH
71868A
8.INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD LH
9.INSTALL FRONT SEAT ASSEMBLY
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
11.PERFORM DIAGNOSTIC SYSTEM CHECK
12.CHECK SRS WARNING LIGHT
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>DIAGNOSIS SYSTEM
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>DIAGNOSIS SYSTEM