Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM › from 2016.03
RM3250E _58 Vehicle Interior _038070 SUPPLEMENTAL RESTRAINT SYSTEMS _0265900 OCCUPANT CLASSIFICATION SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  INITIALIZATION  


NOTICE:

Make sure that the front passenger seat is not occupied before performing the operation.


HINT:
Perform zero point calibration and sensitivity check if any of the following conditions occur:
·

The occupant detection ECU is replaced.

·

Accessories (seatback tray and seat cover, etc.) are installed.

·

The front passenger seat is removed from the vehicle.

·

The passenger airbag ON/OFF indicator ("OFF") comes on when the front passenger seat is not occupied.

·

The vehicle is brought to the workshop for repair due to an accident or a collision.



ZERO POINT CALIBRATION AND SENSITIVITY CHECK


a.

Zero point calibration and sensitivity check procedure

HINT:

Make sure that zero point calibration has finished normally, and then perform the sensitivity check.


i.

Check that both of the following conditions are met:

·

The vehicle is parked on a level surface.

·

No objects are placed on the front passenger seat.

·

The front passenger seat belt buckle switch is off.



ii.

Adjust the seat position according to the table below.

Adjustment Item Position
Slide Direction Rearmost position
Recline Angle Upright position
Headrest Height Lowest position


iii.

Turn the ignition switch off.


iv.

GTS to the DLC3.


v.

Turn the ignition switch to ON.


vi.

Turn the GTS on.


vii.

Enter the following menus: Body Electrical / Occupant Detection / Utility / Zero Point Calibration.


viii.

Perform zero point calibration and sensitivity check by following the prompts on the GTS screen.

OK:

"Zero Point Calibration is complete." is displayed.


HINT:
·

Refer to the GTS operator's manual for further details.

·

If zero point calibration does not complete, replace the separate type front seat cushion spring assembly*1 and front seat adjuster assembly RH*2.

*1: for RHD

*2: for LHD







SENSITIVITY CHECK


a.

Sensitivity check procedure

i.

Turn the ignition switch off.


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on.


v.

Enter the following menus: Body Electrical / Occupant Detection / Utility / Sensitivity Check.


vi.

Perform sensitivity check by following the prompts on the GTS screen.

HINT:

Refer to the GTS operator's manual for further details.



vii.

Confirm that the initial sensor reading is within the specified range.

Standard:

-3.2 to 3.2 kg (-7.0 to 7.0 lb)



viii.

Place a 30 kg (66.1 lb) weight (e.g. a 30 kg (66.1 lb) of lead mass) onto the front passenger seat.


ix.

Confirm that sensitivity is within the specified range.

Standard:

27 to 33 kg (59.5 to 72.8 lb)


HINT:
·

When performing sensitivity check, use a solid metal weight (the check result may not appear properly if a liquid weight is used).

·

If sensitivity deviates from the specified range, retighten the bolts of the front passenger seat without deforming the seat rail. After performing this procedure, if sensitivity is not within the specified range, replace the separate type front seat cushion spring assembly*1 and front seat adjuster assembly RH*2.

*1: for RHD

*2: for LHD