Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH › from 2016.08
RM3250E _53 Suspension _057180 TIRE PRESSURE MONITORING _0279610 TIRE PRESSURE WARNING RESET SWITCH G

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RESET SWITCH  INSPECTION  


PROCEDURE

Hide 84746 1.INSPECT TIRE PRESSURE WARNING RESET SWITCH

a.
C354057C01
1.5,1.25 1.083,0.25 1.083,0.25 0.917,0.25 true 2.25,1.25 2.667,0.25 2.667,0.25 2.833,0.25 true 0.146,0.083 0.531,0.302 0.385,0.219 10 false *a 2.885,0.167 3.25,0.344 0.365,0.177 10 false E 0.552,0.167 0.917,0.344 0.365,0.177 10 false INT
*a Component without harness connected
(Tire Pressure Warning Reset Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (E) - 4 (INT) Tire pressure warning reset switch pressed Below 1 Ω
Tire pressure warning reset switch not pressed 10 kΩ or higher


If the result is not as specified, replace the tire pressure warning reset switch.


b.
C354056C01
2,3.583 2.417,4.438 2.417,4.438 2.583,4.438 true 1.75,1.417 2.5,1.417 true 1.667,3.583 1.333,4.417 1.333,4.417 1.167,4.417 true 0.531,2.5 0.844,2.656 0.313,0.156 10 false *a 2.646,1.323 3,1.51 0.354,0.188 10 false *b 0.74,4.333 1.125,4.531 0.385,0.198 10 false ILL+ 2.646,4.354 3.031,4.552 0.385,0.198 10 false ILL-
*a Component without harness connected
(Tire Pressure Warning Reset Switch)
*b Indicator


Check that the LED illuminates.

i.

Apply battery voltage between the terminals of the tire pressure warning reset switch, and check the illumination condition.

OK:
Measurement Condition Switch Condition
Battery positive (+) →3 (ILL+)
Battery negative (-) → 2 (ILL-)
Illuminates


If the result is not as specified, replace the tire pressure warning reset switch.