Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.08
RM3250E _53 Suspension _057180 TIRE PRESSURE MONITORING _0279817 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


C279757C14
2.083,0.792 2.417,1.021 0.333,0.229 0.094,0.052 0.406,0.25 0.313,0.198 10 false *a 2.125,0.833 2.583,1.031 0.458,0.198 10 false N32
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
- -


a.

Disconnect the N32 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
N32-1 (IG) - N32-12 (GND) G - W-B IG power source Ignition switch ON 10 to 16 V
N32-12 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


b.

Connect the N32 tire pressure warning ECU and receiver connector.


c.

Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

HINT:

Measure the values on the wire harness side while the connector is connected.


E129452C41
1.333,0.708 1.729,0.979 0.396,0.271 0.188,0.115 0.5,0.271 0.313,0.156 10 false *a 1.396,0.771 1.854,0.969 0.458,0.198 10 false N32
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
N32-7 (CLSW) - N32-12 (GND) W-B - W-B Tire pressure warning reset switch
·

Ignition switch ON

·

Tire pressure warning reset switch on


Below 1.5 V
·

Ignition switch ON

·

Tire pressure warning reset switch off


8 to 15 V