Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS › from 2015.11
BM33J0E _V1 General _040402 INTRODUCTION _0201881 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED / RECONNECTED TO BATTERY TERMINAL  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.