FUNCTION
Multi Buzzer
The table below shows the warning and reminder functions of the buzzer in the combination meter assembly.
| Priority | Item |
|---|---|
|
*1: Models with smart entry and start system *2: Models without smart entry and start system *3: 4WD models *4: Models with VSC *5: Models with 6-speed manual transmission *6: Models with automatic transmission *7: Models with Optitron type combination meter assembly *8: Models with diesel engine |
|
| 1 | Unexpected Vehicle Motion Warning (Intermittent)*1 |
| 2 | Unexpected Vehicle Motion Warning (Continuous)*1 |
| 3 | Front Seat Belt Warning (Level 2) |
| 4 | Front Seat Belt Warning (Level 1) |
| 5 | Key Reminder*2 |
| 6 | Front Differential Oil High Temperature Warning*3 |
| 7 | Brake Fluid Low Warning |
| 8 | Engine Switch Operation while Driving Warning*1 |
| 9 | Parking Brake Engaged Warning |
| 10 | Active Test (for Brake System)*4 |
| 11 | Trailer Sway Warning 1*4 |
| 12 | Engine Oil Pressure Warning |
| 13 | Door Open while Driving Warning |
| 14 | Smart Entry and Start System Warning 2 (Intermittent: Maximum 9 Times)*1 |
| 15 | Reverse Warning (for 6-speed Manual Transmission)*5 |
| 16 | Engine Start while Driving Notice*1 |
| 17 | Shift Reject*6 |
| 18 | Trailer Sway Warning 2*4 |
| 19 | Multi-information Display Warning*7 |
| 20 | Fuel Sedimenter Warning*8 |
| 21 | Check Engine Warning |
| 22 | Slip Warning*4 |
| 23 | 4WD Warning (Intermittent)*3 |
| 24 | 4WD Warning (3 Times)*3 |
| 25 | Light Reminder |
| 26 | Smart Entry and Start System Warning (Once)*1 |
| 27 | Immobiliser Certification Reminder*1 |
| 28 | Turn Signal/Hazard Warning Operation |
Multi-information Display (Models with Optitron Type Combination Meter Assembly)
Display Function Flow
The multi-information display can be switched as shown in the flowchart below:
| (1) | Conditions are not met. |
| (2) | Conditions are met. |
| (3) | If there are multiple display requests, items will be displayed in sequence. |
| (4) | Item or display is selected by operating the steering pad switch assembly switch. |
| (5) | ODO display is displayed for a certain period of time after the ignition switch is turned off. |
| (6) | After ignition switch is turned to ON. |
Display Tab Operation
The information currently displayed can be switched using the RIGHT/LEFT switch on the steering pad switch assembly.
| *A | Models with Navigation System | *B | Models with Navigation System or Display Audio System |
| *1 | Steering Pad Switch Assembly | *2 | LEFT Switch |
| *3 | RIGHT Switch | - | - |
| *a | Drive Information | *b | Navigation Information |
| *c | Audio Information | *d | Warning Message |
| *e | Settings | *f | The illustrations shown are examples only. The illustrations may differ from the actual vehicle screen. |
|
RIGHT Switch Operation |
|
LEFT Switch Operation |
Drive Information
Drive information shows vehicle information such as drivable range and fuel consumption.
The drive information can be switched using the UP/DOWN switch on the steering pad switch assembly.
| *A | Models with Eco Indicator | - | - |
| *1 | Steering Pad Switch Assembly | *2 | UP Switch |
| *3 | DOWN Switch | - | - |
| *a | Drive Information 1 | *b | Drive Information 2 |
| *c | Eco Indicator and Eco Judge | *d | Eco Wallet |
| *e | Blank | *f | The illustrations shown are examples only. The illustrations may differ from the actual vehicle screen. |
|
DOWN Switch Operation |
|
UP Switch Operation |
Setting Function
The items displayed on the multi-information display can be customized.
The items can be selected on the information setting screen.
| Item | Available Setting |
|---|---|
|
*: Models with navigation system |
|
| Language | The language displayed on the multi-information display can be selected.
·
English ·
French ·
Spanish ·
Thai ·
Portuguese ·
Indonesian |
| Unit | The unit displayed on the multi-information display, display audio system or navigation system can be selected.
·
km (km/L) ·
km (L/100 km) |
| ECO Indicator Light | The ECO drive indicator light can be switched on or off.
·
On ·
Off |
| TOP Switch Settings | The item that is displayed when the TOP switch is pressed can be selected. |
| Drive Information 1 | 2 items can be selected among the following:
·
Current Fuel Consumption (Bar Display) ·
Current Fuel Consumption (Value Display) ·
Average Fuel Consumption Between Reset Operations ·
Average Fuel Consumption After Engine Start-up ·
Average Fuel Consumption After Refueling ·
Average Vehicle Speed Between Reset Operations ·
Average Vehicle Speed After Engine Start-up ·
Elapsed Time Between Reset Operations ·
Elapsed Time After Engine Start-up ·
Cruising Range ·
Cruising Range After Engine Start-up ·
Blank |
| Drive Information 2 | 2 items can be selected among the following:
·
Current Fuel Consumption (Bar Display) ·
Current Fuel Consumption (Value Display) ·
Average Fuel Consumption Between Reset Operations ·
Average Fuel Consumption After Engine Start-up ·
Average Fuel Consumption After Refueling ·
Average Vehicle Speed Between Reset Operations ·
Average Vehicle Speed After Engine Start-up ·
Elapsed Time Between Reset Operations ·
Elapsed Time After Engine Start-up ·
Cruising Range ·
Cruising Range After Engine Start-up ·
Blank |
| Interruption Display | The following displays that appear as soon as the set condition is met can be switched on or off.
·
Turn-by-turn Navigation Display* |
| Accent Color | The accent color can be changed:
·
Clear Blue ·
Clear Turquoise ·
Deep Orange ·
Radiant Orange |
| Initialization | The setting items can be initialized. |
Warning Mode Function
When a warning is necessary, the warning display interrupts the display in the multi-information display.
The master warning light may illuminate or blink and the buzzer in the combination meter assembly may sound depending on the item displayed on the multi-information display.
| System | Display Message* |
|---|---|
|
*: The warning message differs by vehicle specification. |
|
| Smart Entry and Start System | Shift to P before exiting vehicle |
| Power turned off to save battery | |
| Key not detected Check key location | |
| Smart Entry & Start System malfunction See owner's manual | |
| Turn off vehicle | |
| Key left inside vehicle | |
| Depress brake and then touch key to engine switch | |
| Depress clutch and then touch key to engine switch | |
| Steering wheel lock Press engine switch while turning wheel | |
| Key battery low | |
| Depress brake and then start engine | |
| Depress clutch and then start engine | |
| Push and hold engine switch for emergency stop | |
| Shift to N and press engine switch to restart | |
| Depress clutch and press engine switch to restart | |
| Cruise Control System | Cruise control malfunction Visit your dealer |
| Engine Control System | Low oil pressure Stop in a safe place See owner's manual |
| Water accumulation in fuel filter See owner's manual | |
| Engine oil level low Add or replace | |
| T-BELT maintenance required | |
| Resetting T-BELT maintenance data | |
| T-BELT maintenance mileage ****** km | |
| Check Engine Reduced engine power Visit your dealer | |
| Check Engine Visit your dealer | |
| Reduced engine power Visit your dealer | |
| Engine maintenance required Visit your dealer | |
| Replace fuel filter | |
| Symbol Mark Graphic Display (Charge Warning) | |
| Transmission Control System | Transmission fluid temp high See owner's manual |
| Transmission system malfunction Visit your dealer | |
| Brake Override System | Brake override malfunction Visit your dealer |
| Accelerator and brake pedals depressed simultaneously | |
| Traction Control System | TRC turned off |
| 4WD Control System | 2WD-4WD mode change malfunction visit your dealer |
| Differential oil temp high Cooling time required | |
| Differential oil temp high Shift to 2WD mode Cooling time required | |
| Automatic Headlight Level Control System | Headlight system malfunction Visit your dealer |
Multi-information Display (Models with Analog Type Combination Meter Assembly with Dot Display Type Multi-information Display)
Display Function Flow
The multi-information display can be switched as shown in the flowchart below:
| (1) | Conditions are not met. |
| (2) | Conditions are met. |
| (3) | If there are multiple display requests, items will be displayed in sequence. |
| (4) | Item or display is selected by operating the steering pad switch assembly switch. |
| (5) | ODO display is displayed for a certain period of time after the ignition switch is turned off. |
Cruise Information Display and ODO/TRIP Display
The cruise information display can be switched by operating the DISP switch. The counter can be reset by pressing and holding the DISP switch for 0.8 seconds or more.
| *1 | Steering Pad Switch Assembly | *2 | DISP Switch |
| *a | Blank | *b | Current Fuel Consumption |
| *c | Average Fuel Consumption | *d | Cruising Range |
| *e | Average Vehicle Speed | *f | Elapsed Time |
| *g | Eco Indicator Zone Display | *h | Settings Display |
| *i | The DISP switch is operated for 0.8 seconds or more to customize mode display. | *j | ·
Language Setting ·
Unit Setting ·
ECO Indicator Light Setting |
| *k | The illustrations shown are examples only. The illustrations may differ from the actual vehicle screen. | - | - |
|
The DISP switch is operated for less than 0.8 seconds. |
|
The DISP switch is operated for 0.8 seconds or more to reset. |
Setting Function
The customization display can be switched by pressing and holding the DISP switch for 0.8 seconds or more while the setting display is shown on the cruise information display.
The customization item can be switched to by pressing the DISP switch for less than 0.8 seconds.
| Item | Available Setting |
|---|---|
| Language | The language displayed on the multi-information display can be selected.
·
English ·
French ·
Spanish ·
Thai ·
Portuguese ·
Indonesian |
| Unit | The unit displayed on the multi-information display, display audio system or navigation system can be selected.
·
km (km/L) ·
km (L/100 km) |
| ECO Indicator Light | The ECO drive indicator light can be switched to on or off.
·
On ·
Off |
Warning Mode Function
When a warning is necessary, the warning display interrupts the display in the multi-information display.
The master warning light may illuminate or blink and the buzzer in the combination meter assembly may sound depending on the item displayed on the multi-information display.
| System | Display Message* |
|---|---|
|
*: The warning message differs by vehicle specification. |
|
| Engine Control System | Symbol Mark Graphic Display (Low Oil Pressure Warning) |
| WATER ACCUMULATION IN FUEL FILTER SEE OWNER'S MANUAL | |
| ENGINE OIL LEVEL LOW ADD OR REPLACE | |
| T-BELT MAINTENANCE REQUIRED | |
| RESETTING T-BELT MAINTENANCE DATA | |
| T-BELT MAINTENANCE MILEAGE ******km | |
| CHECK ENGINE REDUCED ENGINE POWER VISIT YOUR DEALER | |
| CHECK ENGINE VISIT YOUR DEALER | |
| REDUCED ENGINE POWER VISIT YOUR DEALER | |
| ENGINE MAINTENANCE REQUIRED VISIT YOUR DEALER | |
| REPLACE FUEL FILTER | |
| Symbol Mark Graphic Display (Charge Warning) | |
| Transmission Control System | TRANSMISSION FLUID TEMP HIGH SEE OWNER'S MANUAL |
| TRANSMISSION SYSTEM MALFUNCTION VISIT YOUR DEALER | |
| Brake Override System | BRAKE OVERRIDE MALFUNCTION VISIT YOUR DEALER |
| ACCELERATOR AND BRAKE PEDALS DEPRESSED SIMULTANEOUSLY | |
| Traction Control System | TRC TURNED OFF |
| 4WD Control System | 2WD-4WD MODE CHANGE MALFUNCTION VISIT YOUR DEALER |
| DIFFERENTIAL OIL TEMP HIGH COOLING TIME REQUIRED | |
| DIFFERENTIAL OIL TEMP HIGH SHIFT TO 2WD MODE COOLING TIME REQUIRED | |