Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › from 2016.07
NM33J0E _58 Vehicle Interior _041114 HEATING / AIR CONDITIONING _0191108 AIR CONDITIONING SYSTEM GE GENERAL F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

An automatic air conditioning system, a manual air conditioning system or a manual heater system is used depending on models.


b.

The automatic air conditioning system uses neural network control to enhance comfort.



SPECIFICATIONS


Automatic Air Conditioning, Manual Air Conditioning System and Manual Heater System
Item Specifications
Automatic Air Conditioning System Manual Air Conditioning System Manual Heater System

*1: On models with manual heater system, the No. 1 cooler evaporator sub-assembly has been provided, but is not used.

*2: Models with 2TR-FE,2TR-FBE, 1GD-FTV, 2GD-FTV engine

*3: Models with 1KD-FTV, 2KD-FTV engine

Blower Motor with Fan Sub-assembly Motor Type 4 Pole Motor
Fan Type Semi-sirocco
Fan Size (Dia. x H) 137 mm x 70 mm (5.4 in. x 2.8 in.)
Cooler Condenser Assembly Type Global Inner-fin Condenser -
Size (W x H x D) 580 mm x 517 mm x 11.5 mm (22.8 in. x 20.4 in. x 0.5 in.) -
Fin Pitch 3.4 mm (0.13 in.)*1
3.0 mm (0.12 in.)*2
-
No. 1 Cooler Evaporator Sub-assembly*1 Type Beneficial Refrigerant Stream (BRS)
Size (W x H x D) 231 mm x 239.5 mm x 38 mm (9.1 in. x 9.4 in. x 1.5in.)
Fin Pitch 3.0 mm (0.12 in.)
Heater Radiator Unit Sub-assembly Type Straight Flow Aluminum (SFA)-II
Size (W x H x D) 222.3 mm x 150 mm x 27 mm (8.8 in. x 5.9 in. 1.1 in.)
Fin Pitch 1.8 mm (0.07 in.)
Cooler Compressor Assembly Type 10SRE11C*2
10S15C*3
-
Refrigerant Type HFC-134a (R-134a) -
Charge Volume 500 g -


MAIN FEATURES


a.

The air conditioning system has the following features:

Feature Outline

*: Models with automatic air conditioning system

High Performance
·

Neural network control is used, so passengers can finely control the air conditioning for maximum comfort.*

·

A pollen removal type clean air filter (air refiner element) is used.

·

The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control.*


Light Weight*
·

A bus connector with a built-in IC is used in a lightweight wire harness design to allow for a reduced number of wires.

·

The use of this connector means that pulse pattern type servo motors can be used.


Others The following parts are used to ensure high cooling performance while achieving a compact and lightweight construction:
·

Semi-center Location Air Conditioning Unit

·

Beneficial Refrigerant Stream (BRS) Evaporator

·

Straight Flow Aluminum (SFA)-II Heater Radiator Sub-assembly

·

Global Inner-fin Condenser (GIC)