Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43360
1.INSTALL FRONT UPPER BALL JOINT
Using SST and a press, press in a new front upper ball joint.
Using a snap ring expander, install a new snap ring.
Make sure the snap ring is securely installed in the groove.
2.INSTALL UPPER BALL JOINT DUST COVER
| *a | MP Grease |
Pack the upper ball joint with MP grease.
8.0 g (0.282 oz.)
Apply MP grease to the locations shown in the illustration.
Do not apply MP grease to the tapered or threaded parts of the upper ball joint.
Install a new upper ball joint dust cover to the front upper suspension arm assembly LH.
Install a new dust cover set ring.
48632B
3.INSTALL FRONT UPPER SUSPENSION ARM BUSH LH
Using SST and a press, press in a new front upper suspension arm bush LH.
48630
4.TEMPORARILY INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY LH
Temporarily install the front upper suspension arm assembly LH with the 2 bolts and 2 nuts.
Fix the nuts in place and temporarily install the bolts.
Install the front upper suspension arm assembly LH to the front axle with the nut.
Install a new clip.
47313J
5.CONNECT FRONT FLEXIBLE HOSE
6.INSTALL FRONT WHEEL
7.STABILIZE SUSPENSION
48630
8.TIGHTEN FRONT UPPER SUSPENSION ARM ASSEMBLY LH
Tighten the 2 bolts of the front upper suspension arm assembly LH.
Do not tighten the nut.
9.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT