Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM(for 2WD)
RM33J0E _53 Suspension _038474 FRONT SUSPENSION _0187662 FRONT UPPER SUSPENSION ARM(for 2WD) G

FRONT SUSPENSION  FRONT UPPER SUSPENSION ARM(for 2WD)  INSPECTION  


PROCEDURE

Hide 48630 1.INSPECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH

C322814

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.98 to 4.5 N*m (10 to 45 kgf*cm, 9 to 39 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.