Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43360
1.INSTALL FRONT UPPER BALL JOINT
Using SST and a press, press in a new front upper ball joint.
Using a snap ring expander, install a new snap ring.
Make sure the snap ring is securely installed in the groove.
2.INSTALL UPPER BALL JOINT DUST COVER
| *a | MP grease |
Pack the upper arm ball joint with MP grease.
8.0 g (0.282 oz.)
Apply MP grease to the locations shown in the illustration.
Do not apply MP grease to the tapered or threaded parts of the ball joint.
Install a new upper ball joint dust cover to the front upper suspension arm assembly LH.
Install a new dust cover set ring.
48632B
3.INSTALL FRONT UPPER SUSPENSION ARM BUSH LH
Using SST and a press, press in a new front upper suspension arm bush LH.
48630
4.TEMPORARILY INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY LH
| *a | Nut |
Temporarily install the front upper suspension arm assembly LH and 2 retainers with the bolt and nut.
Fix the nut in place and temporarily install the bolt.
Install the front upper suspension arm assembly LH to the steering knuckle with the nut.
Install a new clip.
48810
5.CONNECT FRONT STABILIZER LINK ASSEMBLY LH
Connect the front stabilizer link assembly LH to the steering knuckle with the nut.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
89543
6.CONNECT FRONT SPEED SENSOR LH
Install the 2 bolts and connect the front speed sensor LH.
7.INSTALL FRONT WHEEL
8.STABILIZE SUSPENSION
48630
9.TIGHTEN FRONT UPPER SUSPENSION ARM ASSEMBLY LH
Tighten the bolt of the front upper suspension arm assembly LH.
Do not tighten the bolt.
10.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT