Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR(for 2WD)
RM33J0E _53 Suspension _038474 FRONT SUSPENSION _0187666 FRONT STABILIZER BAR(for 2WD) A

FRONT SUSPENSION  FRONT STABILIZER BAR(for 2WD)  INSTALLATION  


PROCEDURE

Hide 48811 1.INSTALL FRONT STABILIZER BAR

a.

Install the front stabilizer bar to the vehicle body.


Hide 48815 2.INSTALL FRONT NO. 1 STABILIZER BAR BUSH

a.
C322853C01
1.083,1.333 1.417,1.333 false 0.917,1.229 1.229,1.427 0.313,0.198 10 false *a 2.76,0.167 3.073,0.365 0.313,0.198 10 false *b 2.917,1.604 3.229,1.802 0.313,0.198 10 false *c
*a Bush Stopper
*b Outer Side
*c Front of the Vehicle


Install the 2 front No. 1 stabilizer bar bushes.

HINT:
·

Install each bush to the outer side of the bush stopper on the stabilizer bar.


·

Install each bush with the slit of the bush facing the front of the vehicle.




Hide 48824 3.INSTALL FRONT STABILIZER BRACKET

a.
C322852

Install the 2 front stabilizer brackets with the 4 bolts.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

HINT:

Make sure the brackets' arrows face the front of the vehicle.



Hide 48810 4.INSTALL FRONT STABILIZER LINK ASSEMBLY LH

a.

Install the 2 retainers, 2 cushions and front stabilizer link assembly LH.


b.
C322851C01
1.979,0.427 2.292,0.625 0.313,0.198 10 true *a 0.583,0.802 0.896,1 0.313,0.198 10 false *b
*a Upper Side
*b Lower Side


Install the front stabilizer link assembly LH with a new nut (upper side) and the nut (lower side).

Torque:
for upper side : 27 N*m (275 kgf*cm, 20 ft.*lbf)
for lower side : 78 N*m (795 kgf*cm, 58 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 48820B 5.INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 51405D 6.INSTALL ENGINE UNDER BRACE SUB-ASSEMBLY

Hide 7.INSTALL FRONT WHEEL

Hide 8.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT