Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR(for 2WD)
RM33J0E _53 Suspension _038474 FRONT SUSPENSION _0187666 FRONT STABILIZER BAR(for 2WD) G

FRONT SUSPENSION  FRONT STABILIZER BAR(for 2WD)  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY

F049932

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.05 to 1.96 N*m (0.6 to 19.9 kgf*cm, 0.5 to 17.3 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.