Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR(for 4WD and Pre-Runner)
RM33J0E _53 Suspension _038474 FRONT SUSPENSION _0187667 FRONT STABILIZER BAR(for 4WD and Pre-Runner) G

FRONT SUSPENSION  FRONT STABILIZER BAR(for 4WD and Pre-Runner)  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY LH

C328536

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.05 to 1.96 N*m (0.6 to 19.9 kgf*cm, 0.5 to 17.3 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.