Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for 2WD)
RM33J0E _53 Suspension _038475 REAR SUSPENSION _0187669 REAR SHOCK ABSORBER(for 2WD) N

REAR SUSPENSION  REAR SHOCK ABSORBER(for 2WD)  DISPOSAL  


PROCEDURE

Hide 48540 1.DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH

HINT:

Use the same procedure for the other rear shock absorber.


C281961C01
2.771,0.25 3.083,0.406 0.313,0.156 10 false *a
*a Approximately 50 mm


a.

Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.


b.

Using a drill or similar tool, slowly make a hole approximately 50 mm (1.97 in.) from the top end of the shock absorber and discharge the gas inside of it.

NOTICE:
·

The gas is colorless, odorless and harmless.

·

Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.