Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for 4WD and Pre-Runner) › 2015.06–2015.11
RM33J0E _53 Suspension _038475 REAR SUSPENSION _0187670 REAR SHOCK ABSORBER(for 4WD and Pre-Runner) A

REAR SUSPENSION  REAR SHOCK ABSORBER(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The RH side rear shock absorber assembly RH lower protector should face to the front side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48540 2.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH

C322861

a.

Support the rear axle housing.

i.

Jack up and support the vehicle's frame on stands.


ii.

Lower the axle housing until the leaf spring tension is free, and maintain this position.



b.

Remove the 2 bolts and 2 rear No. 2 shock absorber cushion washers.


c.

Disconnect the rear shock absorber assembly LH and 4 rear shock absorber bushes from the axle housing and frame.


d.

Remove the 4 rear shock absorber bushes from the rear shock absorber assembly LH.


e.

Remove the 2 rear No. 1 shock absorber cushion washers.