Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
46430
2.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and disconnect the No. 3 parking brake cable assembly from the rear spring assembly LH.
48540
3.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH
48341
4.REMOVE REAR SPRING BUMPER
Remove the 2 bolts and rear spring bumper.
48046A
5.REMOVE REAR SPRING U BOLT
Remove the 4 nuts, 4 washers, 2 U bolts and U bolt seat.
48409A
6.REMOVE REAR SPRING BRACKET PIN SUB-ASSEMBLY (for Single Cab)
Remove the set bolt.
Remove the nut, washer and rear spring bracket pin sub-assembly.
7.REMOVE PIN BOLT (except Single Cab)
Remove the nut, washer and pin bolt.
8.REMOVE SPRING SHACKLE INNER PLATE
Remove the 2 nuts, 2 washers and spring shackle inner plate.
9.REMOVE NO. 2 SPRING SHACKLE SUB-ASSEMBLY
Using a screwdriver, remove the No. 2 spring shackle sub-assembly.
48210A
10.REMOVE REAR UPPER SPRING SHACKLE BUSH
Using a screwdriver, remove the 2 rear upper spring shackle bushes from the vehicle frame.
48220
11.REMOVE REAR SPRING ASSEMBLY LH
Remove the rear spring assembly LH from the vehicle body.