Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
42403
2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
42312E
3.REMOVE REAR AXLE HUB BOLT LH
| *1 | Nut |
| *a | Turn |
| *b | Hold |
Temporarily install 2 nuts to the 2 rear axle hub bolts as shown in the illustration.
Using SST and a brass bar or equivalent to hold the rear axle shaft, remove the rear axle hub bolt LH.
42312E
4.INSTALL REAR AXLE HUB BOLT LH
| *1 | Plate Washer |
| *2 | Nut |
| *a | Turn |
| *b | Hold |
Install a plate washer and nut to a new rear axle hub bolt LH as shown in the illustration.
Using a brass bar or equivalent to hold the rear axle shaft, install the rear axle hub bolt LH by tightening the nut.
Remove the 2 nuts from the 2 rear axle hub bolts.
42403
5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
6.INSTALL REAR WHEEL