Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE(for Front Door)
RM33J0E _59 Vehicle Exterior _038514 EXTERIOR PANELS / TRIM _0188932 BLACK OUT TAPE(for Front Door) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.

·

Fully open the front door glass sub-assembly LH before proceeding with work.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
w/ Curtain Shield Airbag:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
w/ Curtain Shield Airbag:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67492A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 74220 4.REMOVE FRONT ARMREST ASSEMBLY LH

Hide 5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side, w/ Power Window)

Hide 6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side, w/ Power Window)

Hide 69260 7.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 69284C 8.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 67602 9.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 87940 10.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 67832 11.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 68151C 12.REMOVE FRONT DOOR GLASS RUN LH

Hide 68102 13.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 75720 14.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

Hide 68620 15.REMOVE FRONT DOOR CHECK ASSEMBLY LH (for Smart Cab)

Hide 67862 16.REMOVE FRONT DOOR WEATHERSTRIP LH (for Smart Cab)

Hide 67862 17.REMOVE FRONT DOOR WEATHERSTRIP LH (for Double Cab)

a.
B407173

Using a clip remover, detach the clip and remove enough of the upper portion of the front door weatherstrip LH so that the No. 1 black out tape LH can be removed.


Hide 75922M 18.REMOVE NO. 1 BLACK OUT TAPE LH

HINT:

When removing the No. 1 black out tape LH, heat the front door panel and No. 1 black out tape LH using a heat light.


Standard:
Item Temperature
Front Door Panel 40 to 60°C (104 to 140°F)
No. 1 Black Out Tape LH 20 to 30°C (68 to 86°F)


CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



a.
B403629

for Smart Cab:

i.

Pull back an edge of the No. 1 black out tape LH and pull it parallel to the front door panel to remove it.



b.
B403630

for Double Cab:

i.

Pull back an edge of the No. 1 black out tape LH and pull it parallel to the front door panel to remove it.