Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
62180A
1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Attach the clip to set the curtain shield airbag assembly LH in place.
Temporarily install the 2 new bolts.
Install the clip.
Use the same procedure for the other clip.
Attach the claw to connect a new clip.
At this time, do not push in the pin to lock the clip.
Check that the deployment portion of the curtain shield airbag assembly LH is not twisted.
| *a | Pin |
|
Push in this Direction |
Push in the pin to lock the clip.
Lightly pull on the clip to check whether it is locked.
for Single Cab:
Tighten the 2 bolts in the order shown in the illustration.
for Double Cab:
Tighten the 2 bolts in the order shown in the illustration.
for Smart Cab:
Tighten the 2 bolts in the order shown in the illustration.
| *a | Connector Lock |
|
Push in this Direction |
Connect the airbag connector and push the connector lock.
When connecting any airbag connector, take care not to damage the airbag wire harness.
2.INSTALL ROOF HEADLINING ASSEMBLY
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>INSTALLATION
for Double Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>INSTALLATION
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>INSTALLATION
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.PERFORM DIAGNOSTIC SYSTEM CHECK
5.CHECK SRS WARNING LIGHT