Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)
RM33J0E _58 Vehicle Interior _038501 SUPPLEMENTAL RESTRAINT SYSTEMS _0189281 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 72526E 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

Hide 72495 5.REMOVE VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)

Hide 71812D 6.REMOVE FRONT SEAT CUSHION SHIELD LH

Hide 71862 7.REMOVE FRONT SEAT INNER CUSHION SHIELD LH

Hide 8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY LH

Hide 71759C 9.REMOVE FRONT NO. 1 SEATBACK HOOK (w/ Seatback Hook)

Hide 71931 10.REMOVE FRONT SEAT HEADREST SUPPORT (for Low-back Seat Type)

Hide 73920A 12.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

CAUTION:
B399378C01
0,0 0,0 false
V100155

Deployment Side


·

When storing the front seat airbag assembly LH, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.



a.

Detach the wire harness clamp.

NOTICE:

Be careful not to damage the airbag wire harness.


B412941C01
0.24,0.083 0.615,0.385 0.375,0.302 12 false *A 3.688,0.083 4.073,0.396 0.385,0.313 12 false *B
*A for Hi-back Seat Type *B for Low-back Seat Type



b.

Remove the 2 nuts and front seat airbag assembly LH.

NOTICE:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.



B412942C01
0.354,0.094 0.771,0.438 0.417,0.344 12 false *A 3.49,0.094 3.833,0.385 0.344,0.292 12 false *B
*A for Hi-back Seat Type *B for Low-back Seat Type