Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR
RM33J0E _58 Vehicle Interior _038501 SUPPLEMENTAL RESTRAINT SYSTEMS _0189285 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67492A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 74220 4.REMOVE FRONT ARMREST ASSEMBLY LH

Hide 69260 5.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 6.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side, w/ Power Window)

Hide 7.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side, w/ Power Window)

Hide 69284C 8.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 67602 9.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 89835 10.REMOVE DOOR SIDE AIRBAG SENSOR LH

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·
B392779

If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the door side airbag sensor LH. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.




c.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push down the housing lock and slide the CPA. (At this time, the airbag connector cannot be disconnected yet.)

B340847C03
4.26,1.01 4.625,0.594 4.625,0.594 4.979,0.594 true 3.354,1.698 3.594,1.698 3.594,1.698 3.729,1.229 true 3.021,0.438 3.333,0.438 3.333,0.438 3.646,0.76 true 5.031,0.49 5.344,0.646 0.313,0.156 10 false *a 3.177,1.594 3.49,1.75 0.313,0.156 10 false *b 2.844,0.323 3.146,0.531 0.302,0.208 10 false *c
*a Housing Lock *b CPA
*c CPA Upper Part - -



ii.

Push down the housing lock again and disconnect the airbag connector.

NOTICE:

Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.




d.
B409678

Remove the bolt.

NOTICE:
·

Loosen the bolt while holding the door side airbag sensor LH because the door side airbag sensor LH guide is easily damaged.

·

If the door side airbag sensor LH has been dropped, replace it with a new one.




e.

Detach the guide and remove the door side airbag sensor LH.