Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81210B
1.REMOVE FOG LIGHT BULB
for 4WD and Pre-Runner:
Remove the 2 clips.
| *a | 90° |
|
Turn in this Direction |
Turn the pin hold clip 90° and then pull the pin hold clip to remove it.
Remove the 3 screws and 4 clips and disconnect the front fender splash shield sub-assembly LH.
Disconnect the connector.
| *a | Matchmark |
| *b | Unlock Position Mark |
|
Counterclockwise |
Turn the fog light bulb counterclockwise until the matchmark is aligned with the unlock position mark to remove the bulb.
Do not touch the glass part of the fog light bulb.
81210B
2.INSTALL FOG LIGHT BULB
| *a | Matchmark |
| *b | Unlock Position Mark |
| *c | Lock Position Mark |
|
Clockwise |
Align the matchmark of the fog light bulb with the unlock position mark, and then rotate the fog light bulb clockwise until the lock position mark to install the fog light bulb.
Return the front fender splash shield sub-assembly LH to its original position and install the 3 screws and 4 clips.
| *a | 90° |
|
Turn in this Direction |
Insert and turn the pin hold clip 90° to install it.
for 4WD and Pre-Runner:
Install the 2 clips.